INSIGNIA NS-DWF2SS3 Vaatwasser 

NS-DWF2SS3 Vaatwasser

Veelgestelde Vragen/FAQ

Vraag 1: Hoe zet je de startvertraging uit?

Om de uitgestelde start te annuleren en de cyclus te starten voordat de uitgestelde periode is verstreken:

  • Close the door, then press and hold START/Cancel for three seconds.
    OR
  • Press Delay repeatedly until the display shows “O” again.
Vraag 2: Wat moet ik doen als mijn vaatwasser niet start?
  • Zorg ervoor dat de deur gesloten en vergrendeld is.
  • Zorg ervoor dat uw vaatwasser is aangesloten op stroom en is ingeschakeld.
  • Make sure that the Delay Start option is not selected. If it is, press and hold START/Cancel for three seconds.
  • Make sure that the child lock is not turned on. An indicator lights up when the dishwasher is locked. To turn the child lock on or off, press Child Lock and hold for three seconds. The Child Lock indicator turns off.
Vraag 3: Waarom stinkt het?
  • Als de vaatwasser leegloopt in een vuilophaal, zorg er dan voor dat de afvoer helemaal leeg is voordat u de vaatwasser start.
  • Was de filters van je vaatwasser maandelijks voor de beste prestaties.
Vraag 4: Hoeveel ruimte is er op het onderste rek?

The bottom rack is designed to accommodate plates, bowls, saucers, and cookware. The adjustable racks let you load items up to 13 inches high.

Vraag 5: Wat moet ik doen als mijn vaat niet droogt?

To dry dishes, the dishwasher uses a very hot final rinse and then shuts off. As the sides cool, it pulls the moisture off the dishes, to the sides of the dishwasher, and into the drain.

Als uw vaatwasser uw vaat niet volledig droogt:

  • Makes sure that the Heat dry option is turned on. The indicator should be light when you start the cycle.
  • Zorg ervoor dat uw vaat goed geladen is. Plaats uw serviesgoed zo dat het tijdens de cyclus niet verschuift of water ophoopt.
  • Add liquid rinse aid to your dishwasher, or adjust the rinse aid knob to use more rinse aid.
  • Makes sure that your dishwasher’s water temperature reaches at least 120°F (40°C). Turn on the hot water faucet near the dishwasher, and let it run for several minutes. Hold a thermometer (a candy or meat thermometer will work) in the water stream to check the temperature.
Vraag 6: Waarom is mijn vaat niet schoon?
  • Make sure that your dishes are not too close together. See “Preparing and loading dishes” in your User Guide for more information.
  • Zorg ervoor dat u een geschikte wasoptie selecteert. Zie de "Wascyclusselecties" in uw gebruikershandleiding voor meer informatie.
  • Make sure that your water line provides hot water and enough water pressure for the best washing and drying results: Water
    • Water temperatuur: Turn on the hot water faucet near the dishwasher, and let it run for several minutes. Hold a thermometer (a candy or meat thermometer will work) in the water stream to check the temperature. Water entering the dishwasher should be at least 120°F (49°C). If temperature is below 120°F (49°C), have a qualified person raise the hot water heater thermostat setting.
    • Waterdruk: The hot water supply line for your dishwasher must provide water pressure of at least 20 psi (138 kPa) and not more than 120 psi (828 kPa). You may experience low water pressure during high-demand periods, such as when laundry or showers are in use while you are washing the dishes. To eliminate this problem, wait until hot water demand is reduced before starting the dishwasher.
Vraag 7: Ik heb per ongeluk een E9-fout geactiveerd. Waarom en hoe los ik het op?

Deze fout wordt veroorzaakt wanneer u een knop gedurende 30 seconden of langer aanraakt en zelfs water kan deze activeren. De vaatwasser resetten:

  • Unplug the dishwasher, and then plug it back in again.
    OR
  • Reset de stroomonderbreker waar de wasmachine zich bevindt.
Question 8: Does the dishwasher come with a food disposer?

Nee, maar het heeft filters voor voedsel. Het wordt aanbevolen om ze maandelijks te wassen voor optimale prestaties.

Vraag 9: Zijn rekken verstelbaar?

Controleer het modelnummer van je vaatwasser:

  • The NS-DWH 1 SS9 and NS-DWH 1 WH9 do not have adjustable racks.
  • NS-DWRF2SS3 and NS-DWRF2WH3 have adjustable upper racks.

For more information and adjustment instructions, see the User Guide that came with your dishwasher.

Vraag 10: Wat betekenen de foutcodes?

INDICATOR

BETEKENIS MOGELIJKE OORZAAK

MOGELIJKE OPLOSSING

Rinse light blinks and your dishwasher beepsfor15 seconds De waterstroom is onvoldoende of de waterdruk is te hoog
  • Water faucet is not opened
  • Waterdruk is te laag
  • The drain hose is plugged
  • Other (parts failure of inlet or drain system)
  • Make sure that the water is turned on to the dishwasher
  • Make sure that the water pressure is Z0~100 psi
  • Controleer de afvoerslang
  • Contacteer de Klantenservice
Express .and rinse lights blink and your dishwasher beepsfor15 seconds Abnormale verwarming  
  • Contacteer de Klantenservice
Er knippert een zwaar lampje en je vaatwasser piept 15 seconden lang Overloop- of leksensor geactiveerd
  • Een lek
  • Too much water in the tub
  • Turn off water to your dishwasher,
  • then  check the filter system for blockage. Unblock if necessary.
  • If there is no water in the tub, contact Customer Service
Heavy and express lights blinks and your dishwasher beepsfor15 seconds  
  • Contacteer de Klantenservice
De lampjes voor zwaar, snel en spoelen knipperen en uw vaatwasser piept 15 seconden lang    
  • Contacteer de Klantenservice
Normal, heavy, and rinse lights blink and your dishwasher beepsfor15 Communicatie uitzondering of probleem  
  • The display board can’t receive or the main board can’t send a signal for longer than 20 seconds
  • Contacteer de Klantenservice

INSIGNIA -Logo

Documenten / bronnen

INSIGNIA NS-DWF2SS3 Vaatwasser [pdf] Gebruikershandleiding
NS-DWF2SS3 Vaatwasser, NS-DWF2SS3, Vaatwasser

laat een reactie achter

Uw e-mailadres wordt niet gepubliceerd. Verplichte velden zijn gemarkeerd *